Advance Adapters Suzuki Transfer Case 6.40 Low Gear Sets - 48-6400

Rating :- 9.35 /10

Votes :- 16

With air conditioning;Weld-in application;California Residents: WARNING

Advance Adapters Vortec Generation III Motor Mount for Jeep - 713093.These specialty engine mounts from Advanced Adapters will assist you in transplanting a different type of engine in your vehicle will little effort and headache.

Motor Vehicle Engine Parts

The engine side mounts have slots in them so you can position the engine closer to one side of the frame.Frame widths 23.35 to 29.35The engine mount kit includes two engine side mounts, two weld-in gusseted frame mounts, and rubber mount kit.Note: These engine mounts fit the new Gen III / IV, LS-Series V8.

35 to 29.. The mounts have been designed to use with Truck exhaust manifolds or rear dump headers and will interfere with car (Corvette / Camaro / Trans-Am) exhaust manifolds;These engine / motor mounts are commonly used with Jeep YJ Wrangler and Jeep CJ Models;California Residents: WARNING A double rubber cushion on each side provides vibration isolation at the ends of the two mounts.

Engine Conversion Packages

Performance Parts

New transmission output shaft must be installed.

25 and adapter TH400 2WD and 4WD;NP231;Case length is 24.2;California Residents: WARNING Advance Adapters GM TH400 Transmission To NP231 Transfer Case Adapter - 50-6402 Output shaft may need to be shortened or a 1 spacer adapter may need to be used, part #510404).Case length is 24.

Dual Transfer Case Adapter Kit

Please know the transfer case spline count for their input shaft before ordering!

.650. This kit is for use with 1969-86 GM TH 350 2 wheel drive transmission and requires driveline modifications. Replaces Asian AX15 only.

Advance Adapters Ford T&C 4 Speed Transmission To Dana 18/20 Transfer Case Adapter - 50-2100

250 in length. Our kit will include a new transmission main shaft, bushing, gaskets, seal, nylon lock nut, and adapter instructions.

Dual Transfer Case Adapter Kit

The adapter kit includes an adapter housing, new TH400 out put shaft, 6 spline spud shaft, bearing, snap ring, gaskets, seal, fastening hardware, and adapter instructions.

Required Options:716001 Large Hole Retainer or 716002 Small Hole Retainer.D.

The transfer case index to the new adapter will require an index retainer and sealed bearing.

Please I.D.

Included in the kit is: gears, idler shaft, idler bearings, thrust washers, gasket set and instructions.

Transfer Case Low Gear Set

The transfer case index to the new adapter will require an index retainer and sealed bearing.

250 inch hub, 6 spline spud shaft, gaskets, fastening hardware, and adapter instructions. The Borg Warner Super T-10 adapter to Jeep Dana 18 / 20 is 5.

Included in the kit is: gears, idler shaft, idler bearings, thrust washers, gasket set and instructions.

Advance Adapters Transfer Case 6.40:1 Gear Sets;For Use In Suzuki Transfer Case;181% reduction In Low Range;17% Reduction In High Range;Includes Necessary Bearings And Seals;California Residents: WARNING Advance Adapters Suzuki Transfer Case 6.40 Low Gear Sets - 48-6400 These extreme low transfer case gears provide you with a 181% reduction in low range and a 17% reduction in high range..

Transfer Case Low Gear Set